| 合力蓄電池價格 合力叉車蓄電池報價 |
 |
價格： 元(人民幣) | 產地：本地 |
| 最少起訂量：1 | 發貨地：本地至全國 | |
| 上架時間：2019-05-04 09:17:56 | 瀏覽量：154 | |
廣州貝朗斯動力電源有限公司
 |
||
| 經營模式：其他 | 公司類型：生產加工 | |
| 所屬行業：電源管理 | 主要客戶：全國 | |
 在線咨詢  |
||
| 聯系人:陸先生 () | 手機:13538843060 |
電話: |
傳真: |
| 郵箱:1351821115@qq.com | 地址:廣東廣州白云區夏花二路28號 |
|
品牌迅啟,火炬,maci,faam,gs,駱駝,理士 型號24-d-400bs 化學類型鉛酸蓄電池 電壓48v 類型動力型蓄電池 荷電狀態帶液充電態蓄電池 電池蓋和排氣拴結構開口式蓄電池 額定容量400ah 外型尺寸970x600x465mm 產品認證ce 適用范圍叉車蓄電池 票據支持17%增值稅，銷售合同 保修期壹年 適用合力叉車 展開 合力蓄電池價格 合力叉車蓄電池報價 點我去除廣告  合力5噸叉車電瓶屬于安徽heli大噸位電瓶叉車，配上80v650ah，容量大，電力足夠，可起叉4-5噸的貨物，十分夠力，合力蓄電池型號為40-5pzs650h，這款屬于牽引車，可選品牌配套：安徽迅啟，淄博火炬，浙江天能作為動力來源，不同品牌的合力叉車電瓶價格不一樣，廣州貝朗斯動力電源有限公司長期提供原廠的合力電瓶組，屬于一級配套市場產品，質量層層把關，保障了消費者的用車情況。用戶在使用合力電瓶過程中， 電解液面低于極板 由于部隊常年處于“三高”氣候的環境中，水分容易蒸發，如果不及時檢查和添加蒸餾水，會使極板露出液面并與空氣接觸而氧化。在行駛過程中，電解液上下波動，與極板的氧化部分接觸，致使極板上部硫化。擦拭保養不及時 在平時保養車輛時，往往忽視對蓄電池進行擦拭保養，溢出的電解液長期堆積在蓋板上，造成極樁與夾頭腐蝕，產生氧化物，進而在蓋板上形成通路，出現自行放電現象。忽略蓄電池的通氣孔 新蓄電池蓋上的通氣孔是密封的，使用時必須使其導通。否則，在使用中產生的氣體無法排出，蓄電池會因內壓過高而爆炸。蓄電池添加蒸餾水太隨意 通常在加完蒸餾水后，須就車通過發電機為蓄電池充電，使蒸餾水與電解液充分混合，蓄電池性能才不受影響。如果加蒸餾水后長期放置而不充電，蒸餾水與電解液沒有充分混合，就會造成蓄電池的自放電或損壞蓄電池的極性。  合力5t叉車蓄電池充電次數可達1000次以上，賦予高出容量本身的10%，持續工作時間長，適合各種碼頭、、港口、大型倉儲合力叉車使用， 經常檢查正、負極極樁與連接導線接頭之間的連結是否良好 蓄電池正、負極極柱與連接導線之間一般用鐵螺絲作固定連接，電解液又很容易腐蝕螺絲螺母，使連接松動、接觸電阻增大，從而造成電機啟動無力或無法啟動。因此，平時要經常檢查該處是否松動并及時擰緊。此外，還有一個容易被忽略的地方，就是極樁與連接導線接頭之間的2個接觸表面是否有嚴重氧化或污垢，如有，則即使連接螺絲沒有松動，電流流過此處時電阻仍很大，照樣會造成起動機啟動困難或無法啟動。這時，應用刀片將2個接觸表面刮凈后再連接。連接好后，連接處表面涂些黃油或凡士林，以防受電解液的腐蝕和氧化。蓄電池虧電時，要及時補充充電 平時，如發現燈光暗淡、喇叭聲沙啞、啟動無力等現象，說明蓄電池已嚴重虧電。虧電的蓄電池極板很容易被硫化，使蓄電池容量下降，內阻增大，輸出電流減小。這時應及時用充電機對蓄電池進行補充充電，直至電解液中產生大量氣泡為止。蓄電池長期停用時應進行定時充電保養 車輛封存期間，蓄電池一般都應統一集中在蓄電池間，由專人負責維護保管。須知，蓄電池都存在一個內部自放電的問題，每天自放電量約2％，因此，蓄電池必須有專人專室保管，定時檢查，每月至少補充充電1次，每次補充充電分2階段完成：第1階段電流以額定容量的10％進行，時間以10小時左右為宜；第2階段充電電流和時間均減半進行。應重視新蓄電池的初充電 新品干荷蓄電池加好電解液半小時后，雖有電流輸出，可直接投入使用，但為有效地提高蓄電池今后的性能和使用壽命，進行1次初充電后再使用。同樣，初充電也分為2階段來完成：第1階段電流以額定容量的5％進行，時間為30小時左右；第2階段充電電流減半進行，時間為25小時左右。 今年以來，在國內經濟增速放緩，市場競爭進一步加劇的背景下，安徽叉車集團充分發揮合力品牌在市場上的知名度和影響力作用，在逆境中謀增長,一季度，實現叉車銷量2萬多臺，同比增長4%，其中3月份銷量突破1萬臺，再創單月歷史新高。 heli forklift battery belongs to anhui heli 5 tons of large tonnage forklift truck, equipped with 80v650ah, large capacity, power enough, can fork 4-5 tons of cargo, is enough to force, force the battery model 40-5pzs650h, which belongs to the tractor, optional brand matching: anhui xunqi, zibo torch, zhejiang day as the source of power different brands of heli forklift battery, the price is not the same, guangzhou bay power supply co. ltd. has a lens to provide the original force of battery group, a matching market products, quality cengcengbaguan, protect the car consumers. users in the use of force in the process of electrolytic battery, the liquid level is below the plate due to forces in a &＃39;three high&＃39; climate year-round environment, moisture evaporation, if not timely check and add distilled water, will make the liquid surface plate and contact with air oxidation. during the running process, the electrolyte fluctuates from top to bottom, and is contacted with the oxidation part of the polar plate. clean the maintenance is not timely in peacetime maintenance of vehicles, often ignore the battery to wipe maintenance, overflow electrolyte long-term accumulation in the cover, causing very pile and chuck corrosion, produce the oxide, thus forming pathway0n the cover, appear self discharge phenomenon. the air vent0n the cover of the new battery cover is sealed by ignoring the vent of the battery. otherwise, in the use of the gas can not be discharged, the battery will explode due to excessive pressure. adding distilled water to the battery is too arbitrary. after adding distilled water, it is necessary to charge the battery through the generator, so that the distilled water and the electrolyte are fully mixed. if the distilled water is placed for a long time without charging, the distilled water does not mix well with the electrolyte, which causes the self discharge of the battery or the polarity of the battery.  heli forklift battery charging 5t number can reach more than 1000 times, given the high capacity itself 10%, continued to work long hours for a variety of terminals, ports, warehouse, forklift, always check the positive and negative pile and connecting wire joint connection is between the positive and the negative pole and the good battery connecting wire with iron screws are fixedly connected, the electrolyte is easy to corrosion screw nut, the loose connection, the contact resistance increases, resulting in motor weakness or unable to start. therefore, usually to check whether the loosening and tightening. in addition, there is an easily overlooked, is extremely pile and wire connecting joints between the 2 contact surface is a serious oxidation or dirt, if there is, even if the connection screw is not loose, the resistance is still large current flows through here, so the starter will cause difficult or can not start. at this time, the blade will be used to scrape the 2 contact surfaces and then connect. after the connection, the surface of the connection is preferably coated with butter or vaseline to prevent the corrosion and oxidation of the electrolyte. when the battery is defective, it is necessary to recharge the battery in time, such as the dim light, the hoarse voice, the inability to start and so0n. the battery plate of the battery is easy to be cured, the battery capacity is decreased, the internal resistance is increased, and the output current is reduced. at this time, the battery charger should be recharged in a timely manner until a large number of bubbles in the electrolyte. battery maintenance should be carried out when the long-term maintenance of the vehicle during the storage period, the battery should be generally concentrated in the battery room, by the person responsible for the maintenance of custody. notice, there is an internal battery self discharge, daily self discharge of about 2%, so the battery must have special storage room, check regularly, at least a month of charging 1 times, each time of charging is completed is divided into 2 stages: the first stage current to the rated capacity of 10%, the time was about 10 hours suitable; second stage charging current and time of the half. attention should be paid to the new battery charging at the beginning of new dry charged battery with the electrolyte after half an hour, although the current output can be directly put into use, but to effectively improve the performance and service life of the battery in the future, the best for the 1 time at the beginning of charging before use. similarly, the initial charge is also divided into 2 stages to complete: the current phase of the rated capacity of the 5% of the time, the time is about 30 hours; the second half of the charging current of the second phase, the time is about 25 hours. this year, the slowdown in the domestic economy, market competition further intensified in the background, anhui forklift group and give full play to the visibility and influence factors of brand in the market, in the face of adversity and growth, a quarter of forklift truck sales of more than 20 thousand units, an increase of 4%, which in march sales exceeded 10 thousand, hit a record monthly a new high. |
| 版權聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責。機電之家對此不承擔任何責任。 友情提醒：為規避購買風險，建議您在購買相關產品前務必確認供應商資質及產品質量。 |
